|
Description
Don’t just take our word for it. You can now check
for this pollution yourself! A special meter has been developed
which can be plugged into an electrical outlet to determine
the levels of EMF high-frequency pollution in your home
or office both before and after using the HF EMPOR. Extremely
easy to use and reliable.
This meter is designed to measure only the high frequency
noise which may exist in your electrical wiring. It contains
special filters which remove the normal 50/60 Hz signal
for the readout.
The meter is very easy to use. Simply plug the meter into
an electric outlet. The meter works equally well on standard
outlets (2 prong, or 3-prong), and GFI outlets. It can also
be used with surge suppressors, power strips or extension
cords.
The readout of the meter gives an indication of how much
high frequency noise is in the wiring at the outlet where
the meter is located. The higher the readout, the more high
frequency pollution. The readout is not calibrated, but
is very useful for making relative (comparison) measurements.
Ideally, the readout should be as low as possible. It is
generally agreed that readings should be below 50. Notice
that unplugging appliances may affect the reading.
When using the meter in conjunction with the Graham-Stetzer
Filters, plug the meter into the outlet first. Then add
Graham-Stetzer Filters to the same outlet and nearby outlets
and watch the reading decrease.
The use of a power strip to increase the number of available
outlets is useful when you need multiple Graham-Stetzer
Filters to reduce the reading to the desired level.
The meter is re-usable. Can be used on 50/60 Hz, 110-230
V systems. Covers 10 kHz to 100 kHz.
Has standard 2 prong North Amercian plug, so you will need
an adapter to use it outside of N. America.
Click here to purchase
Plug Adapters for International
Use (Order Separately)
|
